Allumium ?

Im an aircraft mechanic by trade, aluminum is your friend! it is very easy to cut, although using a sanding disk with a dremel or die grinder would be preferred.
Just remeber its a very soft metal and will mark up easily. Using a hack saw would be the best hand way to do it.

If you can use a band saw your cooking with gas though!

Any other questions let me know!

DM
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top