HS pistol update! (LONG overdue!)

TB1184

Active Hunter
Long over-due update, though I just recently started working on it again. It's close to being finished, though there are a few details still left to do.

There are two versions of the pistol seen in the HS. I'm mixing the two, and adding some details to "realize" it more.

DSCF0767.jpg

DSCF0769-1.jpg

DSCF0771.jpg

DSCF0773.jpg

DSCF0774.jpg


The front end "knob" detail was sculpted out of plumber's putty, right onto the PVC barrel. The little tube is the tube from a spray bottle, and there are four red wires tucked inside. I'm going to leave the tube clear on the final painting.
 
Great job!! I can't wait until you finish your HS FETT!! It appears to be coming along beautifully!!

If you end up to make a mould of that, I might want one :)
 
Well I finished up the gun tonight. It's 99% ready for paint. All that's left is to sand down the trigger on it, and I can paint it.

DSCF0788.jpg
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top