ESB RIFLE PART HELP PLZ!!!

I used 3/8" plywood. Works great only thing you need to watch is make sure you cut the stock with the grain of the plywood going from front to back not top to bottom. If you do cut it with the grain running from top to bottom it will not be very sturdy.
Mark
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

B0BA FETT25
General Arkady ROTJ Hero Flightsuit color help!
Replies
0
Views
232
B0BA FETT25
B0BA FETT25
Password
Jetpack Rotj Help
2
Replies
37
Views
1,521
Rue1977
Rue1977
Fett78
Boots Best ESB boots suggestions
Replies
3
Views
200
Fett78
Fett78
Romain Vog
Boots Cherche Bottes ESB
Replies
0
Views
233
Romain Vog
Romain Vog
viewoptic
viewoptic's ESB Build
2 3 4
Replies
66
Views
3,784
viewoptic
viewoptic

Similar threads

B0BA FETT25
General Arkady ROTJ Hero Flightsuit color help!
Replies
0
Views
232
B0BA FETT25
B0BA FETT25
Password
Jetpack Rotj Help
2
Replies
37
Views
1,521
Rue1977
Rue1977
Fett78
Boots Best ESB boots suggestions
Replies
3
Views
200
Fett78
Fett78
Romain Vog
Boots Cherche Bottes ESB
Replies
0
Views
233
Romain Vog
Romain Vog
viewoptic
viewoptic's ESB Build
2 3 4
Replies
66
Views
3,784
viewoptic
viewoptic
Back
Top