just to start off with

I have had this jango helmet laying around my house and i didnt have time to start modifing it before dragon con so i was thinking what a great time to start. I didnt take any photos before i got to this point :p but here it is
CIMG0149.jpg

CIMG0148.jpg

CIMG0150.jpg

CIMG0154.jpg

that is a peice of steel to reinforse the cheaks a little more
CIMG0152.jpg

as you can see i cut out the back vent and put bondo in its place and you can see the craft ring at the bottom
CIMG0151.jpg

i got all this done today so i could post it:cheers
 

Attachments

  • CIMG0149.jpg
    CIMG0149.jpg
    82.5 KB · Views: 170
im still thinking what this mando is going to look like paint wise and plus im about to leave for a week and i dont have time to start painting:( :(
but thanks for the info about the ear cap
 
sorry for the long wait but here is a updated pic one sided almost done might git the other side done by tuesday (y)
CIMG0004.jpg

CIMG0003.jpg

CIMG0002.jpg

CIMG0001.jpg
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top