CAD/DXF or PDF's Plans for Gaunt Darts????

womo68

Active Hunter
Hey boys,

Are there any plans out there for the 4 little Boba gaunt darts? Like a place to go and get them?

Or...if anybody has a CAD/DXF PDF set they’d like to send me, that would be great! I have access to a machinist and could make a couple sets.

I tired to contact Russ, but haven't gotten a reply yet and hope this isn't improper to ask for plans. If it is, please let me know.

Trying to get this sucker done by Halloween!

Thanks,
Wayne
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top