How to permanently attach armor ?? w/ pics

Looking good, especially that collar piece thanks to WOF's templates! (y)

And is that weathering I see on the vest itself? Nice touch!(y)
 
In hindsight, we could have just used WOFs great templates to make you all new upper body armor to match that collar piece. Oh well, next time.

Looking good.(y)
 
I wanted to , but we were a little limited on time and I didn't want to use up all your material. I would've felt bad imposing on you like that. BTW got my denim blue RIT and got my hoses good to go. Soaked about 20 minutes.:lol:
 
I was looking on some website (dont remember name sorry) but it had a tutorial on how to perminately attach armor to the flak vest.heres some simple steps to it:

1. take armor plates and drill holes in the corners(not too far in but not right on the edge)
2. put armor on vest and mark holes where they need to be.
3. countersink the holes on the armor and put small bolts in the holes.
4. put car puddy on the bolts outsid and inside the plates.
5. sand extra puddy off to make it smooth
6. put armor on vest and put a nut on the bolts
7. put puddy on the bolts inside the vest.
8. sand extra puddy.

If you do it all right it should be easy to put on and take off. The armor will be comfortabe to wear and plates WILL NOT COME OFF.

**note** this is to be done before painting.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top