Beacon and Stabilizer sign up list

Got mine!!!
icon_cheering.gif


Awesome!!! (y) (y)

I can't wait to see what you come up with next! :cheers
 
Oh...my...god. :eek:

After years of us waiting for someone to step up to the plate, Tim did a fantastic job on these pieces! Mine came in today, too!

I haven't painted my jet pack and I want to install the beacon!
Again, Tim, thanks!
 
Last edited by a moderator:
Anybody want to post some ideas of what they are going to use to light it up?

Check out post number 52 in this thread.
Wire up your LED and drop it throught the "nut" from the top. Put the LED up inside of the beacon to the desired height, then run the wires to your switch or power source of choice :) .
 
I have had some PMs about how these mount.
The stabilizer mounts by simply bolting it on.
The beacon has a "Hollow bolt" so to speak. First, drill your hole in your jet pack, freaky, I know. Then drop your wires in from the top and run your LED up into the beacon and turn it down snug with you hand.
Thats it :) .

One pic is with the flash. The other one I had to turn it off because the LED would not show up.

You could do it however you want but thats how I'm gonna do it.
(LED and wires not included)

-Tim-

For double brightness I will be doing this with several leds. :) I will post pics when I wire it.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top