trash armor..what you think?

thanks so much! here a update of the shouder with decals, and the knee almost finish( wheatering is still missing)......

000_0293.jpg


000_0294.jpg


000_0296.jpg


000_0295.jpg
 
hey, here are some pics of the other knee, unasembled, unpainted to see how it look it before..............
can someone tell to yoda that it´s not a cod?:lol:

Imagen 008.jpg


Imagen 009.jpg


Imagen 011.jpg
 
This is amazing work. I may have to go this route.
Does the paint stick good to the trash can plastic and plastic pipe? does it scratch off easily?
 
so i guess since this is back up at the top again, i'll chime in. what did you use to create the dents in the chest, stomach, and cod? a heat gun and a little bit of pressure? or was there something a bit more devious involved?
 
........thanks, whitewulf!!!!!
the darts are made with a used printer carbridge connector....
the paint stick really good, I give it 2 hands of primmer.......
and yes, saint nasty, I used a heat gun on these one´s.....also in the dent in the pvc helmet I´m builiding on.........
thanks to all!!!
 
great looking trashcan armor. i have a set that i played around with before i started posting. when i go home later this month (hopefully) ill get some pictures of it for ya
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top