Tooth question...

gunnerk19

Active Hunter
I'm looking at TK 409's measurements, and it gives the height of each tooth but not the width of each tooth at the bottom of the visor?

I'm layin' out my marks but I'm stuck without this....:confused
 
I have a mystery helmet, and my measurements for both teeth match his. So, for what it's worth, here's what I measured for the width of each tooth base:

Right: 9 mm
Left: 8 mm

REMEMBER: His diagram defines "right" and "left" with the helmet facing you. So what he indicates as "right" will be your left side if you were wearing the helmet.
 
The bottoms of the face on either side of the visor...
toothwidth.gif


Edit: Thanks Jimmy :)

REMEMBER: His diagram defines "right" and "left" with the helmet facing you. So what he indicates as "right" will be your left side if you were wearing the helmet.

ARG...
Now he tells me :/ Good thing I haven't cut anything yet...
 
That is usualy called the visor here, and the under part its Mandible, we are picky geeks you know. :lol:
 
those are the mandibles.

i am scratch building my bucket and i think i have those measurements way off. Mine are about 13mm :(
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top