ROTJ flamer dimensions?

Ronin677

Well-Known Hunter
Hi all

just wondered if anyone could give me the dimension of the flameras shown in the attached pic.

Also the width of a coax connector (Radioshack type).

cheers

Jon

1untitled1.jpg
 
Jon,
I have a set of Ruffkin's ROTJ gauntlets, and I make that measurement to be 12 3/8", or 314mm. . . depending on which system you're using. ;)

The diameter of the coax parts I used is 5/8", or approx 16mm.

Hope that helps!
 
superjedi said:
Jon,
I have a set of Ruffkin's ROTJ gauntlets, and I make that measurement to be 12 3/8", or 314mm. . . depending on which system you're using. ;)

The diameter of the coax parts I used is 5/8", or approx 16mm.

Hope that helps!

Eric, you are a star. thanks for the info, that is exactly what i need.

:cheers
 
I just noticed this thread and since it is my drawing I figured that I owned you an anwser as well. The flame thrower in the drawings posted above is 12.75".

Alan
 
Dan - thanks for that mate. I just just about to order them from Radioshack but now i can just nip into Maplins on Castlemeadow :) :)

this has made my day.

cheers

Jon
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top