Help With Casting A Project

HeadlessHunter

Well-Known Hunter
Hey Guys, Im currently finishing up the 'master' of my new project, its a Cyberman Helmet from the new series of Doctor Who, the model is constructed of 0.8mm Styrene, lots of bondo and whatever else I could find to build it, I will post pics as I progress further however im looking at help with making a decent copy of it, that I can work on more and then paint up, is there anyone who could help me out with this as I have neither the time, space or knowledge to do it, I would ideally like a fiberglass copy but am open to any suggestions out there, heres a pic of the actual prop, im happy to recieve PM's on this, thanks people

Hero.JPG
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top