Rocket Dimensions

GCNgamer128

Sr Hunter
Hello everybody. As some of you might know I built a jet pack using trash cans, but it lacks a rocket. I would like to find someone out there who has the dimensions of the rocket, size in either Imperial or Metric. I would like the height, width, ect. for each cone and little tiddely bit used on the rocket. I would also need the diameter of the base of each cone.

I plan to build the models in 3Ds MAX to see how it finds out, just to make sure there were no errors in construction. I will then cut the triangular like pieces out of the trash can that I still have left, and heat the up and form them into cones.

The first person who gets me the information I need wins pretty much absolutely nothing except the lingering thought of generosity that will last with them for about 32 minutes!

Thanks!



BH-ANDY
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top