hey guys, I have my helmet cut out and put together, I have two full helmets, one is cardstock, the 110 lb and the other is cardboard.
Even after reading the forums I see the helmet in the pre-hardend phase, then I get lost in the steps up to where they are sanding it all down and fine tuning details. I'm missing Step b in steps a-b-c-d
From what I get there is the Fiberglass and Resin way
There is a bake method though I don't know what material is used to do that
I'm not asking which method is easier I'd like to know exactly how to do each method...even after reading I am still puzzled on how to use the fiberglass and resin.
I also believe there was a hardening agent that can be used on the card stock, that might be the best answer since I have a helmet made in cardstock
((I guess the real problem is that the light hasn't turned on yet as far as understanding how this all works))
Even after reading the forums I see the helmet in the pre-hardend phase, then I get lost in the steps up to where they are sanding it all down and fine tuning details. I'm missing Step b in steps a-b-c-d
From what I get there is the Fiberglass and Resin way
There is a bake method though I don't know what material is used to do that
I'm not asking which method is easier I'd like to know exactly how to do each method...even after reading I am still puzzled on how to use the fiberglass and resin.
I also believe there was a hardening agent that can be used on the card stock, that might be the best answer since I have a helmet made in cardstock
((I guess the real problem is that the light hasn't turned on yet as far as understanding how this all works))