Right hand ROTJ gauntlet query

Ronin677

Well-Known Hunter
Hi ppl

only me again. I am in the middle of converting my gauntlets to ROTJ and have noticed a piece on others r/h gauntlets that i don't know anything about (see the pic). its the tube like bit under the long box section. (btw that is not my gauntlet, hope i don't upset anyone by using their pic)

Could anyone give me more info, dimensions or pics on this piece please. Also what connections i need to use in the ends.

sorry to come on this forum asking questions again.

Jon

right sanded.JPG
 
that's my gaunt... a progress pic... but I guess that's a little more then just obvious ^^

I just used a wooden dowel inside a pvc pipe that was sawed of under an angle and put some metal things on the dowel that looked ok and to wich I could easily attach my hoses.

the part should be thinner then on my pic, but I had a pvc pipe floating around at the time.
 
RBF said:
that's my gaunt... a progress pic... but I guess that's a little more then just obvious ^^

I just used a wooden dowel inside a pvc pipe that was sawed of under an angle and put some metal things on the dowel that looked ok and to wich I could easily attach my hoses.

the part should be thinner then on my pic, but I had a pvc pipe floating around at the time.

A belated thank you for letting me use your pic :cheers
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top