Blaster ROTJ Recipe

A finished one for a Swedish Fett.

ROTJ nilz wip 7.JPG

SAS
 
sidewinder no offense but the hammer isnt supposed to be back on the blaster if you drilled the plate out in front of it, it would go right into place and not be like that
 
I think you may want to look at reference pics sir, the hammer is back compared to where it should be, half cocked or cocked its not where it should be
 
WoW :eek: you are firing out EE-3´s kits weekly right now , such an beast ;)

Nice to see that so many peoble want that awesome kits :D

They are looking great , keep on rockin !
 
Last edited by a moderator:
This thread is more than 8 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top