slave1pilot
Well-Known Hunter
I have been commissioned my a member here to re-do some painting on an MR Boba Fett Helmet.
this is the Signature Version.
He does not want it to look as if it is mass produced and would like it to better match the weathering on his armor & jetpack etc.
I am not completely redoing this helmet nor am I fixing the pinch, only adding to what is there and most importantly....
Fixing how the dent was painted!
MR didn't even get close when aligning the stencil over the dent.
See?
Look how "off" that dent is. Anyone else have this same problem?
so...
I masked off a small area and airbrushed the area I was gonna work with.
Then I masked where the dent is and sprayed that silver
Here is where it is now.
I still have a lot to do around the dent, but wanted to show the beginning.
this is the Signature Version.
He does not want it to look as if it is mass produced and would like it to better match the weathering on his armor & jetpack etc.
I am not completely redoing this helmet nor am I fixing the pinch, only adding to what is there and most importantly....
Fixing how the dent was painted!
MR didn't even get close when aligning the stencil over the dent.
See?
Look how "off" that dent is. Anyone else have this same problem?
so...
I masked off a small area and airbrushed the area I was gonna work with.
Then I masked where the dent is and sprayed that silver
Here is where it is now.
I still have a lot to do around the dent, but wanted to show the beginning.