Hi Garrett, I was wondering if you could post your kill stripe dimensions. I've laid out a masking tape guide on my helmet, but it doesn't look right.
I guess I need the height and width of your stencil, the distance the stripes are apart from one another, and the distance above the red band. Do you start on the left one , right one, or middle ? I tried to line up the 7th stripe using the center line of the ear as a guide, but it looks off on one end or the other.
I have a WIP thread for my helmet, but after looking over this tutorial, I'm going to re-do my back panels yet again. The way you have it broken down helps a lot.
Thanks for any assistance, I hope all is well,
Tim