Ok, The good news and bad news thus far.
Heres a pic of the good and the bad. Heres the first full pull tonight. Came out great. From 2 feet away its perfect.
However when you get up close, theres a spot on the dart launcher rear that has a seep line. What this means is that the model came un-sealed when i removed my mount. Some silicone got under it. A paper thin sheet. So you have essencially a paper thin gap in the rubber. Third picture.
I didnt see this on my first pull, because I didnt use enough rubber to fully pull that side of the mold
So the top was just missing. Its also on an undercut so on initial clean up, id idnt see it. Today I saw part of it, but didnt know how far it went till I got home.
I still give these an 8.5 - 9 right out of the mold. But they arent 10's.
Anyone thats made a mold of this magnitude knows that you rarely get perfect.
The problem here is the mold has to be 'hot' when you pour the rubber. Or it wont cure properly. So I had to make it a big block mold.
A 4 gallon block mold. Which cost $649for just the silicone from alumilite. Im telling you thyis because if it was a 10 dollar mold. Id remake it. Even a hundred dollar mold. But I cant remake a 600 dollar mold:/
That being said examine the pictures and if you want off the list, pm me. I personally cant see the line from 2 feet away.