Rangefinder circuits, official sign up thread

Wow, I am into the third run already! I think the first run filled within a couple hours! Ok, I believe I have contacted the first 10 to post or PM me, and you are now signed up as the first run. If you intend to drop out, please PM me ASAP so someone else can move up. I will start putting together the waiting list for the next run. Don't worry guys, I hope to do enough runs to get everyone that wants one. Thanks
 
The first run is under way. I have started production last night:cheers Payment information has been sent to everyone on run 1. I must stress again, please let me know ASAP if you are dropping out or want to be moved to a later run. It makes a difference on the versions I build, and allows someone else to move up. It will take me a few weeks to get the first run done, I will then contact the next run with payment info, and repeat the process. Board measurements are up now- about 1 1/8 inch square. I found a way to cut out just a little more and may get them down to about an inch square, maybe a little less. For the time being, use 1 1/8 to make sure they will fit in your topper. Thanks
 
How the heck did I missed this thread?

Please add me to the list.

Been waiting for this list since you started the JB thread.

Thanks
Arturo
 
Yeah, I realize I never saw lights on his RF. I'm alright for getting away from that little bit of accuracy. What lights should be blue you think Fox, all three? I guess I have to think about making a hollow RF top to fit my BKBT RF arm.
 
I don't know what is accurate for Jango. Right now, the Jango's are requesting blue LED's instead of red. Will be checking with my supplier to see about getting blue LED's.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Bigdane
  • Sale Sale
For Sale Bigdane Jetpack harness kit.
2
Replies
22
Views
2,289
Bigdane
Bigdane
r3klus
DIY BOBF belts
Replies
2
Views
1,341
r3klus
r3klus
azheat01
My Custom Carded George Lucas 6" Figure
Replies
17
Views
1,768
DennisFett1142
DennisFett1142
The Sweatshop
Mandalorian Super Commando (Ahsoka) Parts Identification & Discussion
Replies
0
Views
415
The Sweatshop
The Sweatshop
MachineCraft
Definitive Metal Ears for Lineage Helmets - MachineCraft Replicas
2 3
Replies
44
Views
10,443
MachineCraft
MachineCraft
Back
Top