My Finished Gauntlets

BobaN00b

Active Hunter
My Finished Gaunts

I was never happy with the paint job that the SFP Gauntlets have, so I repainted them, added the light, etc. The rocket and darts are machined aluminium, I bondo'd over the switches on the right gaunt and the hose attachment area on the left. Changed the flamethrower nozzels to something better.

g9.gif

g8.gif

g7.gif

g6.gif

g5.gif

g4.gif

g3.gif

g2.gif

g1.gif
 

Attachments

  • g9.gif
    g9.gif
    6.4 KB · Views: 110
  • g8.gif
    g8.gif
    6.4 KB · Views: 101
  • g7.gif
    g7.gif
    6.4 KB · Views: 116
  • g6.gif
    g6.gif
    6.4 KB · Views: 116
  • g5.gif
    g5.gif
    6.4 KB · Views: 118
  • g4.gif
    g4.gif
    6.4 KB · Views: 137
  • g3.gif
    g3.gif
    6.4 KB · Views: 122
  • g2.gif
    g2.gif
    6.4 KB · Views: 98
  • g1.gif
    g1.gif
    6.4 KB · Views: 114
Nice paint job. What are the darts on the right gaunt? They look like drill bits.
 
Last edited by a moderator:
Thats the way they came. They are FAR from accurate, I know, but they will do until I get new ones. All I know about them is they are all the same size and are machined. They look different sizes because when I removed the, I chunked the gaunt and had to glue them back in and some of the glue/bondo collected inside the holes, giving them the un-even-ness.
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top