Too cold to Resin Gaunlets?

That's what I did( not build a missile!). My wife was all " what the hell is that smell?"
And I was like...shoulder shrug....
 
what type of resin are you using? i am a newbie collecting info on the different resins and plastics to use for casting. any info i can get will help (especially with avoiding ticking the wife off with various smells and messes :)
 
@maximus4241, typically standard bondo type fiberglass resin and matte for glass. Not sure about the gelcoat that would go in first. Probably best to get all of that online from a marine material website.
As far as the white plastic, Smooth On makes different urethane plastic materials at different cute times.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top