Boiling Sintra?

darthvince

New Hunter
I am about to start molding my armor out of 3 mm Sintra. and was planning on trying the boiling water technique.

Just wondering if I can use my household pots, or will molding them ruin the pot? Want to double check before I ruin my girlfirends cooking stuff :lol:.
 
The pots will be ok. Honestly though, while you're fiddling with the gf's kitchenware, just pop the sintra piece in the oven. It sounds scary, but I find it much easier.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top