Range Finder Stalk Question

kf990

New Hunter
I was trying to see if anyone had a template or pattern for the stalk for a range finder I have searched every where
thanks for any help
 
Also try this Ken:
URL="http://www.thedentedhelmet.com/f23/range-finder-blueprints-templates-10800/"]http://www.thedentedhelmet.com/f23/range-finder-blueprints-templates-10800/[/URL]


Or are you hoping to do this for cnc or autocad?
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top