Shin tool measurement (Sonic Beam Weapon)

Triple d

Hunter
Ok. I must be blind. I have looked at most of the threads and can't find what the length of the Patterson Squeegee needs to be cut to. I looks like it is supposed to be a little bit below the last screw hole. I looked at the templates but couldn't find the measurement for it. Any body got a sec to measure theirs and let me know. I have it done except for the length. Once I get it I will prime it and paint it.

Thanks
 
Ok. Duh. Had a senior moment there. Had to use my brain on this one. Printed out WizardofFlights template (8 1/2 x 11 paper) and held it up to it. Duh.

:)
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top