Jump suit modifications

lordfett

Active Hunter
Am just getting started making my jump suit, and i had a thought about it. I used to work on uhaul trucks and they had work coveralls for us, i was always ripping the seat of mine out when i'd bend over for a tool, my solution to this problem was to basically cut the suit in 1/2 (to pants and jacket) then re-attach the two parts with a girth of elastic.

Has anyone tried this or had a similiar problem with ripping their seat out?
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top