Clearcoat and scotch guard for sealing/waterproofing?

A

Arakus

Hunter
I've used Rustoleum's clearcoat/sealer before and that seems to work pretty good. However, I have not tested it on any rainy days. Does anyone use anything waterproofing and sealing your paint job?

I've also considered using scotchguard for protecting the weathering on the softparts? Has anyone tried this method?
 
Testors Dullcote I've found sealed my helmet paintjob perfectly. As a matter of fact
I found it out today cause it poured all day and I took my lid somewhere to show it off.
Not sure about the Scotch Guard. Good Luck!
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

MAULFETT
Jabba throne for My Boba Fett throne
Replies
0
Views
368
MAULFETT
MAULFETT
B
glazing putty and moisture?
Replies
0
Views
728
badlandsghost
B
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
917
Rook 3
Rook 3
coastlineamps
Air Brush Techniques and Tips
Replies
2
Views
1,594
coastlineamps
coastlineamps
Badjudget
Coating for my Helmet?
Replies
1
Views
1,335
Rook 3
Rook 3

Similar threads

MAULFETT
Jabba throne for My Boba Fett throne
Replies
0
Views
368
MAULFETT
MAULFETT
B
glazing putty and moisture?
Replies
0
Views
728
badlandsghost
B
Rook 3
Q: Best filament for helmet/armor printing?
Replies
0
Views
917
Rook 3
Rook 3
coastlineamps
Air Brush Techniques and Tips
Replies
2
Views
1,594
coastlineamps
coastlineamps
Badjudget
Coating for my Helmet?
Replies
1
Views
1,335
Rook 3
Rook 3
Back
Top