Helmet question

Laan

Active Hunter
This may have been brought up before. But I may have a different situation, which is I cant think straight.

I want to put install a servo in my MS3. But I can figure out how much modification will need to be done on the helmet. The pics below are what I have. Need more pics, let me know too.

Any ideas will be great. Thanks.

Ooops, I meant to put this in the Helmet secion.

Picture 011.jpg


Picture 012.jpg


Picture 013.jpg
 
Hi Todd,
If you look at post #38 in this thread:

http://www.thedentedhelmet.com/showthread.php?t=17063&highlight=accurate+ears

it shows a curved "slot" cut into the inner ear piece. . . although I think that's probably for the wiring to light the LEDs. You shouldn't have to do much to modify the ear piece for a servo. Maybe just widen the center hole where the stalk pivots to accept the servo arm.
Of course, I've never installed a servo, so maybe someone with a little experience will reply. :)
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top