j/w what is the best way

i have these two tools i used to trim my AP set. i dont know what theyre called, but I will take some pictures tomorrow and bother my dad about it, lol.

actually i lied, i know the name of one tool. It's called OLFA HOME SCISSORS. They can pretty much cut through anything. The scissor blades are serrated. Pics tomorrow.
 
I used tin snips to get the rough cuts, then run the piece on a bench belt sander to get to the line, then a quick finshed sanding by hand. If your doing an AP kit you can score it with a utility knife or xacto and snap it off after. Called score and snap. I was skepitcal too, till I tried it.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top