Rubies Jango !

get a different helmet.

seriously though, i;m not sure that a rubies 1 or 2 piece jango can be sufficiently modified to pass as a canon jango costume. at least not without alot of $ and work. if that's the direction you're wanting to go, a new bucket would be the way to go.

however, if you're set on using the rubies jango for something, you can get a decent shape from it by lightly warming it and reshaping it. then stick it in the freezer or cold water for a couple minutes to set it. installing a craft ring in it's base and in the dome will help to hold the shape. although being a vinyl helmet, it can still suffer warping even with those installed.
 
Thank you for your advice ! The rubie helmet is for practice only and i will give them to my kids when finished and i hope to buy a decent helmet from Bobamaker when i have the funds ! Thanks again !
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top