Ammo Belt Scratch Build

Jedi killa 73

New Hunter
I started this using Tk409's pouch pattern and went from there. I will say print your templates a few percentage's smaller as the vinyl will stretch and you will have to trim up a few (I had to trim 8 ). All that is left to do now is the pouch covers and sewing everything. BTW...did I mention that I hate the sewing machine.

I will put completed pics up when I am done. Would love to have some feedback.

000_0625.jpg


000_0626.jpg


000_0627.jpg


000_0628.jpg


000_0629.jpg
 
Last edited by a moderator:
i plan to weather it as soon as i get the covers for the pouches finished and the stitching done on the belt but i am unsure quite how to go about weathering vinyl...any advice would be appreciated
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top