Shin tool progress

cookiemongoloid

Active Hunter
Well, I ordered my Paterson Squeegee, and it is on the way...But I am WAY to impatient to wait for that to come, so I started on the anti-security blade. I too, used a spatula. (thanks for the slavepilot1).

pic 1. I started by doing a series of long math equations to try to figure out the dimensions of only the spatula part by looking at a picture.
Picture020.jpg


I tried to cut off the uneven part, and made a big hole


pic 3.
I was curious, so I tried to fill the hole with hot glue from a hot glue gun. Now at this point, I was thinking that I am spending too much time trying to fix something that is worth no more than a dollar, but I refused to accept defeat, so I will complete this even if it takes forever.
Picture022.jpg
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top