Darthmillers FP V3 armor

DarthMiller

Well-Known Hunter
Well....I am working on my personal FP V3 armor at the same time I am doing the JB project. Its kinda fun doing an ESB for Jeremy the same time I am working on ROTJ for myself.

anyway...here are a few pics....still have a long way to go on the weathering!!

DSCF0005-1.jpg
 
Last edited by a moderator:
and a look at my new mannequin...thanks to Spideyfett for my new pose!!

lots of work still left on my knees, shoulders and some final weathering on the armor

should be done by next week

IMG_1122.jpg
 
Last edited by a moderator:
(y) (y)

I've been dying to see darts installed in these ! That's awesome Jason ! Doesn't look like it was too bad, huh?

:cheers

FP
 
the secret on these is to use a Boring Bit to drill the hole

I actually put the resin part in the knee to add support and then drilled with the boring bit right through the knee and then the resin piece

here is a example of the drill bit I used





(y) (y)

I've been dying to see darts installed in these ! That's awesome Jason ! Doesn't look like it was too bad, huh?

:cheers

FP

tt203151.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top