ESB visor crack, Done before or after filming?

Lynn TXP 0369

Well-Known Hunter
Does anyone know if this crack was done before or after filming?
Any ideas?
Has anybody tried to replicate the ESB visor crack on their buckets?
Helmet_crack.jpg


I will be adding it to mine, replicated of coarse, not going to actually crack the bucket though.
I will probably scribe it in and smear a little epoxy over it too look like it has seeped out of the edges and on the surface like in the pic, the epoxy will yellow on it's own in time.

Lets see your pics if anyone else has tried it.

Lynn
 
I painted my MHK ESB-style. Funny thing, is that when I took the old visor out to replace it, the paint cracked in that exact same location.

Must be a high-stress area...
 
From the photos I have seen, I do not believe it was cracked during ESB.

esb.nocrack.jpg


esb.nocrack2.jpg


Now the pics aren't the best, so it's impossible to say anything definite.
 
Thanks for the pics, it dosn't look it. But like you said nothing definatly definative.

I think the crack makes it look more used though.

Lynn
 
I think someone had taken it off good ole JB and took it back to costumes and looked at their watch and...OOPS!! Nice bucket on the pavement.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top