Fin's on Blaster,, Help Please

shortimer52

Well-Known Hunter
I was wondering what everyone was using for the cooling fin's on the barrel of the blaster. Ive looked and i cant figure it out.
 
They were rubber windshield wiper fins, the same type people use as grips on their sabers and the fins on the stormtrooper blasters.
 
One alternative I have used on previois blasters was gluing strips of sintra (sheet plastic) to the barrel to simulate the fins. I suppose the best would be a centimeter (3/8" for you yanks) strip of 2mm sintra topped with a smaller strip of 3 mm sintra creating an inverted "T" shape.

Of course, the preferred thing is to abandon the Fett project, get a DC-15 (aka a real man's gun) and some clone armor and defend the Republic. :lol: Then again, I may be biased. 8)
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top