Gloves-feedback please

sargonkiadi

Active Hunter
I just dyed, and sewed on patches for my second pair of boba fett gloves. The first pair was spray painted gray...:lol: I believe these turned out a bit nicer. Lemme know what some of you think, suggestions, etc. Thanks.

DSCF0571.JPG
 
Is there any padding under the sewn on white bits? I've heard of others here that have done that, and i think the originals were slightly padded, although I have been know to be wrong from time to time. Otherwise looking good. Thanks for the idea about the spray paint btw
 
Looks like a good start.

Where did you get your base glove from?

What type of material are you using for the padding? Is it cotton?
 
For the base glove, I used what tk-409 suggested on his website, at some parade gloves.com site. (can't remember off the top of my head)

There is no padding underneat the cotton white tips, but that is a grand idea, and I think that i'm going to add that to make them look a bit bulkier! Thanks for the idea.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top