Templates

I looked thru them and didnt see what im looking for. Im looking for roughly how far from top edge and left edge of where to cut out openings to install display. If there even is a specific measurment
 
Here are the measurements for the chest light cut out:
Chest Display Placement.jpg


The placements for the jetpack top greeblies:
Jetpack Top Basic Measurements.jpg


And some measurements for the right gauntlet darts:
PP2 ROTJ SE Right Gauntlet Darts Measurements.jpg
 
Yes perfect. Do you charge for your services were these located on this forum somewhere if not what about the 2 switches for right gauntlet and are those gauntlet darts the same for esb version. Thanks for your help
 
Yes perfect. Do you charge for your services were these located on this forum somewhere if not what about the 2 switches for right gauntlet and are those gauntlet darts the same for esb version. Thanks for your help

Some of these images are scattered in different threads and weren't posted in a template thread. The position of the darts is more or less the same on all gauntlets. The right gauntlet switches position is not in the same place on all gauntlets.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top