Attaching shoulder studs

Malaven

Hunter
Hey guys,

I have a quick question about the shoulder studs that go on the upper most neck piece of armor. How do you attach these in a fashion that will not warp/hurt the armor (mine is sintra cast) and will be strong enough to hold up the cape?

Thanks!
 
mine are screwed through the armor.

head of the screw on the inside, passing through the collar and backplate, with the stud acting as the nut.

if you're worried about the plastic, just reinforce it on the inside... glue a couple of extra layers of plastic in for extra support, then drill through 'em all.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top