Boushh Boushh Project

psydaz

Hunter
Hey all,

Here is another project I am working on. This costume will be for my wife. It is still and progress and REALLY time consuming. I will post more pics as I progress.

Thanks to Skip for his help with this project!!!


DSC03773.jpg


DSC03774.jpg


DSC03775.jpg


DSC03776.jpg


DSC03777.jpg


DSC03778.jpg


DSC03779.jpg


DSC03780.jpg


DSC03784.jpg


DSC03785.jpg
 
:D Great start (y), i started the boushh project for my other half about two years ago but sadly the fett took over, sold my lid on fleabay, :facepalm...error.

keep this thread going though buddy, nice to see a boushh progress thread again.
 
Looking Good Andrew!!

I'll have to enlist your fine building skills on a helmet project I got. ;)

U shoulda come over last night...the armor party was fun...

also...

More progress today...Should have this model done tonight!

DSC03795.jpg


DSC03797.jpg


DSC03798.jpg
 
Last edited by a moderator:
You guys absolutely amaze me! I have no idea how you use the pc to print this out and then to glass or bog it all up is awesome to watch. You truly have skilled fingers and mind mate!
 
Ok
I know I'm a bit of a noob here and this question probably has been asked allot but, where do you get / find / download / request these papercraft, pep? layouts and how do they do it?

can anyone direct me to a website or person or thread to help me?

I really want to try one of these lids and dont know where to start.

any help is greatly appreciated.

btw that Boushh lid looks awesome cant wait to see it glassed up....

thanks guys
ashgad
 
It looks great buddy, you're off to a great start on it. Though one thing, that sensor/visor looking thing that sits just above the actual visor is too high up. It needs to be a little lower down so it's more centered on that plate it fixes to.

Can't wait to see more of this mate. :)
 
It looks great buddy, you're off to a great start on it. Though one thing, that sensor/visor looking thing that sits just above the actual visor is too high up. It needs to be a little lower down so it's more centered on that plate it fixes to.

Can't wait to see more of this mate. :)

Ya, I know...I just have it taped there for the time being.
 
Thanks for the link Skip...your work is amazing I'll be in touch real soon as soon as I figure out what to attempt first....

-A
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top