Interest Thread: Machined U-Clips for carbonite panels!

kurtyboy

Active Hunter
Looking for more interest to get another run of the machined U clips done. These are the twenty metal clips seen on the carbonite panels (they are on all but the hero panel) folded from sheet steel in an accurate one-piece design.


"When resin just won't do!"


Here are some pictures showing them on my own carbonite block:
panels31.jpg



panels30.jpg



panels29.jpg



panels41.jpg



Complete set of twenty clips plus all the screws (three accurate types) and hex nuts for attaching them will be £85 plus shipping with half payable up front once we have enough interest. Not taking any payments until it's a go!


PM me please if you're in.
 
i would love to get in on this, but it won't be until september at least before i could swing it.
 
I have just started aquiring pieces to build HIC. I will be getting Han shortly, I have the box and I would like to get the clips. Let me know if it is still possible to get in on this.

Thanks
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top