ADVICE NEEDED Han solo in carbonite

Huntman

Active Hunter
Alright. I have both my fett costumes finished ( except for the occasional upgrades) Now for THE best part I want to start on the HAN in Carbonite. I cannot beleive there is not a thread somewhere about it. Who has done it where do i start?????
 
azheat01 built one from scratch and has it on display in his theater room along with some Ikea cases filled with action figures, not to mention his other costumes...look for threads started by him, it's been awhile.
 
Well, see the side panels on the IC han in carbonite are not the same as the ones in the movies.

There are two different panels also, (if i remember right) on the IC han.

Those can be cast also. Best to cast them in brush on resin then foam.

But they arent very 'clean' very uneaven surface detail. Id have to do a lot of cleaning.

On the bright side, they screw off I think.
 
I'm going to be doing a short run of side panels if you are interested?

Making copies of the IC sides, or scratch building your own? Im going to redo my entire HIC with more screen acurate pieces. Id like to see pics of your elec side boxes if they arent just direct casts from the IC han
 
I am definitely interested in some side panels. I am going for the movie accurate look as well. If I see what Im looking for I can send payment immediately. I am excited to get started and would like to aquire my materials before I begin. I appreciate any info that can be provided.
 
I remember this link was very informative, however the pictures have been removed. What was the reason for removing the photos?
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top