Woodmans' Comm. Gree build thread

woodman

Active Hunter
I have updated everything possible on my Fett so I have been able to start on my next project, Ep. III Comm. Gree. I have been gathering parts for almost a year now and have everything but the undersuit and boots which I will figure out later. I am working on losing some more weight before I put out the bucks for a vertical ribbed one.

I painted the helmet a while back and have started at the logical place from the ground up. Mojofett is making me some aluminum boot strap discs, I dont see any grees with them they are plain to see in freeze frame, he is also making me an accurate antenna for the radio pack.
Well here are some pics of my stuff and some WIP shots of the spoons.
Here's a list of my parts:



Helmet-Armor Depot Florida from ebay, nice helmet, resin casting
aluminum aerators from EVO3
visor from Fenixprops
armor from Armor Depot Florida except OSCS thighs and shins short set
belt from Steelblitz
compad,elbow,knee and shoulder straps from Steelblitz
Thermal Dets and brackets from Steelblitz
Blaster by Greedo
Radio pack from SEEKER
all leather gloves

100_0268..JPG


100_0281..JPG


100_0276..JPG


100_0271..JPG


100_0266..JPG


100_0273..JPG


100_0270..JPG


100_0277..JPG


100_0278..JPG


100_0279..JPG


100_0267..JPG


100_0274..JPG


100_0275..JPG
 
Lookin good. Gree is a tough build, but I know you can do it. I built my friend's 41st elite and was started on my set, but I didn't like how it was fitting me. I am going to get another armor kit soon. If you need any tips just say the word.
 
Thanks, I was going to build a shocktrooper at first but Gree just seemed to call me. He has a look similar to Fett with all weathering and offered much more of an interesting project to me. I sure do have alot of work ahead!
 
did some work on the right calf and spoon. here are some pics of me gluing the backup strips and the shin in a nifty clamp I made. I got the idea fro "The Woodchuck" if you dont know him me's an older fella on CTN that makes the most awesome blasters and other stuff from of course wood anyway you lay the shin or thigh or forearm on some poster board and trace along the contour then
cut the line then transfer it to a strip of wood , cut the contour so you end up with 2 boards that match the shape of the 2 pieces you need to clamp together and you can use 2 C-clamps to clamp the full length of the seam.
also some pics of the lock tab set-up to hold the spoons in, credit goes to KW designs at OSCS,
and the seam before filler.

100_0285.JPG


100_0298.JPG


100_0286.JPG


100_0283.JPG


100_0284.JPG


100_0287.JPG


100_0297.JPG


100_0299.JPG


100_0282.JPG
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top