tusken raider

slimguy379

Jr Hunter
well over the past, ohhh,.... week i have been trying to make a tusken raider helmet. its a tusken raider so its not that difficult to accomplish but i feel as though i did a decent job (so far) as you can see from the pictures it originally started as a balloon and carboard, i then paper mached it with newspaper and wallpaer paste. it held up decently. after that i bought a bowl from the dollar store and added it to the back because the the newspaper wasn't gunn'a pull it off. i then invested it about $10 worth of fiberglass materials. i then fiberglassed the majority of the inside. NOTE: since the clothe is gunna be put over the head you can also fiberglass the outside without any quality of the "look" lost. the eyes are 1.5" pvc, the teeth is a chunk of 2"x2" cut out with a band saw. the cheeck things are dowels. all painted with silver spray paint. i then hot glued shaded visor in the pcv eyes. the visor was left over from my boba helmet, (check my boba scratch build out as well) right now im waiting for the fiberglas to harden then im gunna lay down the clothe hopefully ill upload some pictures.
picture.php
picture.php
picture.php
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top