Stormy Helmet kit help

JCent105

Jr Hunter
Hey all I have just recently begun trimming my ANH stormtooper helmet and i am a little confused on trimming. I followed the guide I found here http://www.applingmedia.com/TK-4510_Helm_Inst_LR.pdf. I Have pictures of what I have done. Any help would be greatly appreciated.

Thanks,
JC

2010-12-27_17-55-39_425.jpg


2010-12-27_17-54-27_319.jpg


2010-12-27_17-53-58_668.jpg


2010-12-27_17-54-37_116.jpg


cap-right.jpg


cap-front.jpg
 
Im not sure if my trimming is correct. I trimmed only enought to where I was comfortable but I would like guidance lol and when I put them together by hanf my head does not fit...
 
Tk helmets typically have to be put on sideways and then turned to get your head in.

Just don't slit your throat before you get that bottom trim installed. ;)
 
It's been a while since I cut and assembled my AP helmet. And, unfortunately, I no longer have it.

However, I will say that I am not sure about the cut you made on the dome/back half. As far as I remember, the ear pieces should cover the seam/overlap of the mask and rear portion of the helmet. I suggest a trial fitting to see where you are at.

Good luck, Brother! :cheers
TK 4667 Helmet.jpg
 
aside from having to clean up rough edges, that looks about right. is that an ATA helmet? if so, don't be surprised that it's tight. mine is too. gotta put it on sideways then screw it on. also note that the face won't line up right with the dome... there will be gaps. that's normal for this kit.
 
To be honest all I know is that it is an ANH helmet, but the back piece where it is rounded at the bottom it came like that. Thats why I was worried it doesnt look right. I bought 2, one for me one for my brother and both of them came with that rounded spot. Will the ears cover that up? It is the first picture. Also sorry for the dumb question but where is a good place to get TE2 armor? I am looking for a place, have yet to find anything.
 
The cap needs a little more off the brow and the right side. The bottom opening of the faceplate needs some attention too. Follow the mold lines. As Naglium said, head over to First Imperial Stormtrooper Detachment or Mos Eisley Police Department. Read some threads and you will find your answers.
 
Last edited by a moderator:
To be honest all I know is that it is an ANH helmet, but the back piece where it is rounded at the bottom it came like that. Thats why I was worried it doesnt look right. I bought 2, one for me one for my brother and both of them came with that rounded spot. Will the ears cover that up? It is the first picture. Also sorry for the dumb question but where is a good place to get TE2 armor? I am looking for a place, have yet to find anything.


Definitely spend some time at the FISD forum. helmets derived from originals are all sorts of messed up... warped, asymmetrical, bumpy, messy... you really need to learn about the quirks before you go ahead.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top