Starkiller Attempt 2

dynamic1

Active Hunter
Hey all- Here is the glassed armor. What a pain! anyhow, it has turned out pretty well (w/ some help) however, its a bit snugg thru the chest which was a result of my "not so good" manaquin. I am thinking of just using this as a cast and maybe sculpting some sintra over it? What are some thoughts? Maybe cardboard and spakle?
Thnx
B

starkiller_glassed.jpg
 
Hey ogait- The photo is w/ fiberglass and rough layer of bondo. Because it is a bit snugg I thought maybe I can just use it as a cast mold for a different material such as sintra or something else. What do u think?
 
I have never worked with sintra. However, I don't think sintra will fit the shape. I mean, you can get the main shape that covers the shoulder itself... but the neck part will be more difficult. Since sintra is cheap, I suggest you try it first and if you don't like the results sand the original piece and go for the long route (silicon-latex mold + fiberglass casting)
:)
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top