CT01125775
New Hunter
Hi all, I'm working on a pepakura AotC clone trooper but found that some parts, specifically the ab, hand, elbow, knee and boot plates might be better accomplished through sheets of plastic bent to shape. I have been looking around for good armor templates and flatpatterns but I can't seem to find any. If anyone has any that they are willing to offer, that would be excellent. However, if not, I would really appreciate any dimensions available for the armor above, that way, I could produce a template from the measurements.
If anyone has a clone trooper kit that they would be willing to take these measurements from for me I would really appreciate it. The dimensions I would need for each piece would be:
Ab plate:
-Max./Min. height
-Front (top edge) Slope start point/end point
-Approx circumference
-Min./Max. height/width for front grooves
-Angle/curvature of flare for front grooves
-starting height for flare on front grooves
-placement location of holes in ab plate
-middle section (between grooves) height/width and slope/flare (if any)
Hand plate:
-Min./Max. width
-Length
-Angle measurements
Knee plate:
-Height/Width of overall plate
-Height/width of area where strap is attached
-Height/width/depth of center box-like projection
-Angle measurement/approximate curvature of the edges
Elbow:
-Height/Width of overall plate
-Height/width of area where strap is attached
-Angle measurement/approximate curvature of the edges
Boot Plate/Strap:
-Length/width
-curvature
-angle measurements
This is a lot of work and any help will be deeply appreciated. Hopefully from this information, and some good reference images, I can engineer some templates which I can share on this site.
Any help is welcomed: ref images and dimensions.
Thank you all so much!
If anyone has a clone trooper kit that they would be willing to take these measurements from for me I would really appreciate it. The dimensions I would need for each piece would be:
Ab plate:
-Max./Min. height
-Front (top edge) Slope start point/end point
-Approx circumference
-Min./Max. height/width for front grooves
-Angle/curvature of flare for front grooves
-starting height for flare on front grooves
-placement location of holes in ab plate
-middle section (between grooves) height/width and slope/flare (if any)
Hand plate:
-Min./Max. width
-Length
-Angle measurements
Knee plate:
-Height/Width of overall plate
-Height/width of area where strap is attached
-Height/width/depth of center box-like projection
-Angle measurement/approximate curvature of the edges
Elbow:
-Height/Width of overall plate
-Height/width of area where strap is attached
-Angle measurement/approximate curvature of the edges
Boot Plate/Strap:
-Length/width
-curvature
-angle measurements
This is a lot of work and any help will be deeply appreciated. Hopefully from this information, and some good reference images, I can engineer some templates which I can share on this site.
Any help is welcomed: ref images and dimensions.
Thank you all so much!