Phase 2 Clone Trooper Helmet

rabbiter

New Hunter
Hi everybody,

I am new to this board. So first of all a gib hello to you all! :)
I begun modelling a phase 2 clone trooper helmet. I am planning on building a costume for me and my pals.
It is really hard to find a sizing.
Maybe here is someone who ownes a good helmet with canon sizing.
Can anyone of you tell me the length and width of the helmet at the black rim above the eyes.

Thank you

ma_e.jpg
 
Hey Rabbiter! Not sure if you've got the measurements yet, but i'll measure my helmet out and let you know!

By the way, what program are you using to design this helmet?
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top