My OSCS 501st bucket (finally) done

hansoloway

Well-Known Hunter
I got this OSCS clone kit over a year ago and have finally gotten it to this point. I've built and painted up many different helmets in my day, and I have to say, this was the most difficult. More difficult than Fett you say? Well not the paint job, but cutting out the front of the helmet so it can fit around my melon, that was a pain in the neck. For those who don't know, with this bucket, the front gets cut out right in front of the ears and then the faceplate is the re-attached with magnets.

Anyway, I like it, here are some shots:)

persp.jpg


front.jpg


side2.jpg


back.jpg


side1.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top