Hasbro Clone

How hard would it be to add some extra plastic to the visor area to make it less wide? Then you could bondo over the seam, sand the whole thing, primer it and spray it white again, maybe a simi-gloss?
 
I went to an event yesterday and the other guy (after some malfunctions with the regular helmet) resorted to using one of these on his ARC trooper. A very nice helemt. I'm going to get one once money allows.

the light, unfortunately does not light up, but the helmet is amazingly comfortable.
 
I have one on order, should be here tomorrow with any luck, I will be doing a step by step conversion into an AOTC version with the narrower visor, as well as tidying up all the joins etc (y)
 
Got myself one :)

No time to mod but I will for sure - really nice lid even standard but Im waiting to see how you folks go with your mods... hopefully by the time Im ready there will be templates up somewhere!

On another note - and this may be somewhat cheeky - the red Target/Walmart helmet... is that an online offer only? Any chance a US TDH member could pick me one up if I paypaled the cash first?

Thanks folks,
Dave
 
How hard would it be to add some extra plastic to the visor area to make it less wide? Then you could bondo over the seam, sand the whole thing, primer it and spray it white again, maybe a simi-gloss?

That's what Brisk did to his, hope he doesn't mind I put up his picture, but it just looks great!
IMG_1453.jpg
 
Yes step right up check out my cough...amazing thread.......:lol: no, In my humble opinion its best to dismantle the helmet and build it up that way.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top