Female Tusken from the Dunesea

Jarvis

Active Hunter
I'm doing a test fit of my Female Tusken castings that were cast in cold cast Bronze . These out door pictures don't really do it much justice as far as seeing the shine of the bronze so please take a look more at the details in the sculpt .
When you look at the mask you get the feel that this was actually pounded metal that had been shaped , folded , spot welded , torn in spots and repaired , on the squares either side of the mask if you look close you see a repeating nick in some of them suggesting those squares were by a craftsman with certain way of doing his job different from others , On the lower edge of the mask there are rips that had been repaired where the metal had gotten to thin during the pounding process , the metal above the eye opening you can see the spot welds and how it was seamed together attaching the sides and the middle . The center detail was made to match as close as possible to the screen used mask taking two hours the owner of our local bead shop to find just the right beads .The inner skirt attention was paid to the pins and small straps . Some detail is still missing on the forehead only because I haven't cast them yet .
Take a look and as always feed back is appreciated.
Thanks
IMG_1812.jpg

IMG_1813.jpg

IMG_1815.jpg

IMG_1817.jpg

IMG_1816.jpg

IMG_1821.jpg

IMG_1824.jpg

IMG_1825.jpg

IMG_1822.jpg

IMG_1819.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top