Custom Mando

soilman

Active Hunter
It's been a long time since I have been on dented helmet since I finished my ESB Fett in 2005. Fett is really starting to show wear and I have outgrown it something fierce so I have decided to do a custom Mando for something unique and different and also I am building it for comfort in mind. I am progressing pretty good and I am going to really try to have it done by the end of August 2013 for fall events and cons.

mando.jpg

mando2.jpg

mando1.jpg

mando3.jpgmando4.jpgmando4.jpgmando5.jpgmando6.jpgmando7.jpgmando8.jpgmando9.jpgmando10.jpgmando11.jpgmando12.jpgmando13.jpgmando14.jpgmando15.jpgmando15.jpgmando17.jpgmando18.jpgmando19.jpgmando20.jpgmando21.jpg


here is what I have so far. I cant wait to get it all done and I really like doing something that has leaway so I don't have to find this exact color paint etc.

I have also made Obi-Wan ROTS, Cobra Commander, Shazam, and Green Arrow.
 
Last edited by a moderator:
Hi !
wow, I´m loving what what you´re doing with the chest and back plates. what material(s) are you using?
anyway, keep it up, looking amazing! I´m super excited for more updates :)
Ghost
 
I got a sheet of 090 plastic from a local sign company for about $40 for a 4'x8' piece. I have used 4'x4' so far and the only armor I still need to do is the shins and a little more for my cod piece. I cut it out using the templates from mando mercs. I heated it and shaped it with boiling water and steam, but you can use a heat gun. I just cant find one for less that $40 in this area of North Dakota.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top